Ferrocement Photo Gallery

Ferrocement Photos

Click to view full size image

Photo 23

Here's the nitty gritty. This was the biggest bear to fight, getting the mudinto the mesh without voids. On a hunch I stopped by the local OSH hardwarestore and purchased toilet plungers to force the ECC mud. ...Any trick inthe book and then some. While holding four of them in my arms in theshopping isle, the guy next to me commented on the plumbing problem I musthave. He was a concrete engineer and we talked for an hour. He approved ofmy 'manual hydraulic mortar emplacement tool'. I'll explain how one must'roll' the mud into place to avoid voids. I learned it decades ago in dentallab on the plaster bench. Like a slow motion tsunami wave you push orvibrate the wet material outward directionally, never gulping air, neverencapsulating air or creating bubbles. You watch the leading edge of your'wave' as it consumes everything in it's path in slow-mo. Doing this with atoilet plunger was a new wrinkle. The 3 sizes of trowels were helpful butcouldn't generate the pressure needed to get the mud thoroughly through thewire mesh and protruding out below, like a meat grinder making hamburger. Weare talking about very physical work here. Given the time constraints ofinitial set, we really put our weight into the job. When satisfied withpenetration we then plopped on a mound of mud and spread it out on top,level with the aluminum angle forms. Last I floated a smooth finish andcrawled under the step to begin smoothing out the bottom. We are talking areal hump job here, given the time constraints of the setting ECC mortar. Ithelps that we had three of us, one continually mixing small batches, and twoothers schmushing and finishing. Also the days were cool, slowing the set.

ted24.jpg ted25.jpg ted23.jpg ted22.jpg ted21.jpg
Rate this file (Current rating : 3.7 / 5 with 3 votes)