Ferrocement Photo Gallery

Ferrocement Photos


Photo 27

Below is the mix low down, and above is another view of work in progress. After completion I wet cured the steps for a full 30 days before use. A temporary ramp with barriers protected the steps from all use. The steps were covered with plastic sheet and plywood mockup cutouts. The work was also tented tightly in 6 mil plastic sheet with 2 large shallow water filled plastic cement mixing tubs placed inside to keep the air humidity high for 30 days. The weather was Southern California December, 52-60 degrees F shaded from sunlight by the house eves and surrounding trees for great slow sets and a long, strong cure.ECC MIX MATERIALS:
1) Graded feldspar silica blasting sand, bagged and dry mixed in nearly equal portions by weight: #16, # 20, #30, #60, #90, #120 grit
2) Portland cement, low alkali, type II/V
3) 100% Acryl 60 (no water)
4) PVA (Poly Vinyl Alcohol) REC15 fibers 1/4" grid woven wire steel mesh (M/Steel, 4 X 4, 1.190 wire, roll 36"W x 111'L)MIX RATIOS BY WEIGHT:
The first batch was weighed with a scale in ounces, each separate ingredient placed on the scale in plastic Straus brand yogurt containers: 317 oz sand (combined weights), 60 oz cement, 4 to 7 oz PVA fibers (under 2% by weight), 19 oz Acryl 60 or more but kept to the bare minimum possible except in the batches being pushed into the interior of the space frames.
MIX RATIOS BY VOLUME: The weights chosen closely resemble the volume ratio of 1:3 cement/sand.MIX TOOLS:
A) Milwaukee heavy duty 1/2" angle drive drill, 4.5 amps, 0-500 rpm
B) Onebone style mixer, homemade, metal blades on all-thread
C) 5 gallon plastic buckets, half filledMIX METHOD:
The dry mix was given a short stir with the Onebone mixer, the liquid was immediately added, and all mixed for 30 to 60 seconds at 150 to 300 RPM.SET CONTROL:
Cool days and the Acyrl 60 gave us an hour to apply each batch of mix as long as it was spread out and not massed in any container where chemical reaction heat could accelerate the set. (Each stair step took 4 to 6 buckets half filled.)BUBBLES: Slow rising air bubbles were a problem if the surface was float-troweled too long. The Acryl 60 did not let bubbles rise and dissipate easily. Various vibration techniques were briefly tried but not liked. Short slow power mixing, the no-air-encapsulation mud application technique previously mentioned, and a quick and efficient trowel finish on the top were the answers to bubble potential. "Johnny, don't play with your potatoes!"

ted28.jpg ted26.jpg ted27.jpg ted24.jpg ted25.jpg
Rate this file (Current rating : 1 / 5 with 1 votes)